furnace-tune-up

What Is Included in Your Tune Up

15-Point Gas Furnace Tune Up

  • Cycle the furnace
  • Limited blower cleaning
  • Clean or change filter (customer supplied or purchased from contractor)
  • Verify limit operations
  • Clean flame sensor
  • Cycle condensate pump (90% or better EF)
  • Measure and record amp draw to blower
  • Rate/set furnace input
  • Inspect flue pipe & Pressure Switch Operation
  • Clean burners
  • Tighten electrical connections
  • Clean exterior
  • Brush and inspect heat exchanger
  • Conduct bubble test for gas leaks (if needed)
  • Vacuum burner compartment

10-Point A/C Tune Up

  • Cycle the air conditioner
  • Test total refrigerant pressure
  • Test outdoor ambient temperature
  • Test indoor ambient temperature test
  • Test amperage draw on fan motors
  • Oil motors
  • Check integrity of electrical contactors
  • Tighten electrical connections
  • Check indoor coils (drain properly)
  • Inspect and wash outdoor coils